Changeset dff57b4 in mod_gnutls


Ignore:
Timestamp:
Nov 25, 2015, 7:24:01 PM (4 years ago)
Author:
Thomas Klute <thomas2.klute@…>
Branches:
debian/master, debian/stretch-backports, jessie-backports, master, upstream
Children:
3ccceed
Parents:
412ee84
Message:

Update documentation for TEST_IP and "--disable-flock"

Files:
3 edited

Legend:

Unmodified
Added
Removed
  • configure.ac

    r412ee84 rdff57b4  
    6262dnl Optionally disable flock
    6363AC_ARG_ENABLE(flock,
    64         AS_HELP_STRING([--disable-flock], [Disable use of flock during tests]),
     64        AS_HELP_STRING([--disable-flock], [Disable use of flock during tests \
     65        (some exotic architectures don't support it)]),
    6566        [use_flock=$enableval], [use_flock=yes])
    6667dnl If flock is not disabled, make sure it's available
  • doc/mod_gnutls_manual.mdwn

    r412ee84 rdff57b4  
    3131:   Provides a list of all available configure options.
    3232
    33 It is recommended to run `make check` before installation. If
    34 `localhost` does not resolve to the IPv6 loopback address `[::1]` on
    35 your system, you may have to set the `TEST_HOST` or `TEST_IP`
     33It is recommended to run `make check` before installation. If your
     34system doesn't have a loopback device with IPv6 and IPv4 support or
     35`localhost` does not resolve to at least one of `[::1]` and
     36`127.0.0.1`, you may have to set the `TEST_HOST` or `TEST_IP`
    3637environment variables when running `./configure` to make the test
    3738suite work correctly.
  • test/README

    r412ee84 rdff57b4  
    2525test and don't want to wait for the full test suite to run.
    2626
    27 The default configuration assumes that an IPv6 loopback device is
    28 available (TEST_IP=[::1]) and that TEST_HOST="localhost" resolves to
    29 the IPv6 loopback address [::1]. If this does not apply to your
    30 system, you can pass different values to ./configure, e.g. to use IPv4
    31 instead:
     27The default configuration assumes that a loopback device with IPv4 and
     28IPv6 support is available (TEST_IP="[::1] 127.0.0.1") and that
     29TEST_HOST="localhost" resolves to at least one of these addresses. If
     30this does not apply to your system, you can pass different values to
     31./configure, e.g. to use IPv4 only:
    3232
    3333  TEST_HOST="localhost" TEST_IP="127.0.0.1" ./configure
     
    9292 * they need a functioning loopback device.
    9393
    94  * they expect (by default) the TEST_IP to have port 9932
    95    open. [TEST_PORT]
     94 * they expect (by default) to have port 9932 [TEST_PORT] available
     95   and open for connections on the addresses listed in TEST_IP.
    9696
    9797 * if a machine is particularly slow or under heavy load, it's
Note: See TracChangeset for help on using the changeset viewer.